ENVY Standard Quad H Clamp

List price: Inward Price: You save:
$ 30.00 $ 29.00 $ 1.00
In stock 0

This Envy H (headset) clamp was designed to replace the headset dust cap offering a clean transition between the Head tube and Bar.  This Envy H standard pro scooter clamp prevents scooter bars from snapping above slit. The top half of the clamp reinforces the down tube of the pro scooter bar. The quad clamp is designed for standard 1 1/4" outside diameter scooter bars. This clamp is made of hot forged 6061 aircraft aluminum and comes in several painted colors.

Recommended Bar Slit Length: 1.5 inch

Category
Scooter Clamps
Weight
0.33 lbs (151 grams)
Type
Standard Scooter Clamp
Brand
Envy
Bolt
6mm
Clamp Height
2.8"
Finish
Painted
Material
6061 Aluminum

Tools:  Allen wrench metric # 5, Ball bearing grease or anti seize compound .

Instructions:
Remove Headset Dust Cap. Put grease on the bolt threads and under the bolt head. Place the clamp around the bottom of your pro scooter bar. Line up with slit in bar.  Slide the bar over the fork steerer tube till it hits the top of the headset. Line up the bar with the pro scooter fork and front wheel. Tighten the bolts with a 5mm allen wrench. Switch between bolts while tightening to ensure even clamping and prevent stripping the threads. If you use ICS compression, tighten the compression before tightening the bolts on the clamp.

Does NOT fit steel oversized or aluminum bars.

Recommended Bar Slit Length: 1.5 inch

90 days manufacturer warranty.